Antminer Fan Shroud for 6″ Ducting
The Antminer series of miners can be incredibly noisy devices and put off a lot of heat and are designed for use in industrial settings, rather than home or office environments.
Adding an Antminer fan shroud to your setup solves this problem by allowing you to duct the heat of the Antminer outside of the room or building.
Out of stock
The Antminer series of cyrptocurrency miners can be incredibly noisy devices and put off a lot of heat. Antminers are designed for use in industrial settings, rather than home or office environments. The Antminer comes with two very loud fans producing around 200 CFM of airflow through the miner. Heat from the miner is generally radiated into the open room where it resides, which can be very troublesome for those who run Antminers in their garages or other types of non-industrial settings as there is nowhere for this heat to escape. Adding an Antminer fan shroud to your setup solves this problem by allowing you to duct the heat of the Antminer outside of the room or building.
Antminer 120mm Fan to 6 Inch Duct (152mm) Features
- Dramatically reduces noise
- Keeps the Antminer cooler
- Use with existing mounting hardware
- Works with 6″ flex ducting or standard AC ducting
- High quality PLA plastic for long life and durability
- Highest quality finish of any shrouds
- Rigid mounting base
- Flexible duct sleeve
- Allows for removal of the fan grills*
6 Inch Antminer fan shroud vs 4 Inch Shrouds
Don’t be fooled by those offering 4″ shrouds (102mm) for the Antminer. These ducts are too small and can reduce airflow by as much as 25%! The only way to achieve maximum airflow is with a 6″ Antminer fan shroud and 6″ (152mm) ducting. The 6″ Antminer shroud can be used with flex ducting or with standard AC ducting. This will result in the highest possible airflow through the miner, resulting in the best heat exchange for the electricity usage.
The 6″ Antminer fan shroud can be used on any of the following Antminers:
- Antminer S7/S9
- Antminer L3+
- Antminer A3
Quieting the Antminer by Removing the Antminer Fan Grills
The Antminer fan shroud allows for the removal of the Antminer’s safety grills (the fan grills). These grills are one of the major sources of noise from the Antminer. The fan grills cause much of the high pitched whistle that is heard when the Antminer is running at mid to full RPM (4500 to 6000 RPM). Because the Antminer fan shroud and ducting covers the fan completely, the grills become no longer necessary.
*Warning: Do not remove the Antminer grills unless you have ducting or other adequate protection in place! These fans will cause severe damage to human hands!
|Dimensions||12 × 10 × 6 in|